LVLHED is used to set up your bow with a new sight. It helps you level your bow so you can match your sights first, second, and third axis. And no one does it faster than LVLHED.

100%

If you can screw in a bolt, like most idiots can, you can screw in LVLHED.

X-Axis: Locate the berger hole on your bow (this is usually found in the center of the riser). Place the threaded end of the level in the hole and screw clockwise.

Y-Axis: Locate the factor hole at the top of the riser. Screw in the level clockwise.

Follow your bow manufactures leveling instructions to dial it in perfectly.

You can scew it in on either side. If you screw it in on the inside of the bow, you may need to run a tap first to clean out the finish that may be on the threads.

No, LVLHED is only for use while setting up your bow.  We do recommend you have them with you when you're in the backcountry on a remote hunt, in case something happens where you need to check and make sure things are still level.

2 levels come in a package.

Yes, you can use LVLHED to set your third axis.

One LVLHED weighs around 125 grains or about 8 grams.